Filter
Top Products
9
CONNECTING TWO ICS Sub 24’s
You may wish to use two ICS Sub 24’s, particularly if you are in a large room.
Double subwoofers may be wired
with either speaker-level or line-level
connections.
Be sure the Phase Switch is set the
same on both units.
To connect two ICS Sub 24’s using line-
level inputs, use "Y" connectors to daisy
chain the ”PREAMP OUT“ signal to the
input of a second ICS Sub 24.
80 Hz
60 Hz
70 Hz 100 Hz
125 Hz
50 Hz
CROSSOVER LOW LEVEL IN
LR
HIGH PASS OUT
LR
150 Hz
THX INPUT
Bypasses Crossover
80 Hz
60 Hz
70 Hz 100 Hz
125 Hz
50 Hz
CROSSOVER LOW LEVEL IN
LR
HIGH PASS OUT
LR
150 Hz
THX INPUT
Bypasses Crossover
ICS Sub 24
Amp
ICS Sub 24
Amp
Amplifier, Receiver or
Preamp/Power Amp
PREAMP
OUT
AMP
IN
L
R
To connect two ICS Sub 24’s using speaker-level inputs, use the ”HIGH LEVEL IN FROM AMP“ binding posts on one
subwoofer to daisy chain to the second ICS Sub 24.
ALWAYS ON
0°
PHASE
180°
HIGH LEVEL IN FROM AMP
L
+– R+–
HIGH LEVEL OUT TO MAIN SPEAKERSAUTO ON
ALWAYS ON
0°
PHASE
180°
HIGH LEVEL IN FROM AMP
L
+– R+–
HIGH LEVEL OUT TO MAIN SPEAKERSAUTO ON
+
LR
-
Amplifier, Receiver or
Preamp/Power Amp
Connect the main speakers
directly to the system's
amplifier to run the main
speakers full range.
Connect the main speakers to the
High Level Outputs to take
advantage of the high pass filter
in the ICS Sub 24 amp.