Filter
Top Products
INSTALLATION & OPERATION
5
SECTION 4
SPECIFICATIONS
Type:
Six Channel audio amplifier
Power Output: Continuous Average Power (120
VAC)
200 Watts into 8 Ohms, 1 Channel Driven
300 Watts into 4 Ohms, 1 Channel Driven
450 Watts into 2 Ohms, 1 Channel Driven
150 Watts into 8 Ohms, 6 Channels Driven
250 Watts into 4 Ohms, 6 Channels Driven
300 Watts into 2 Ohms, 6 Channels Driven
Intended Specification For Theater Application:
200 Watts into 8 Ohms, 5 Channels and 400
Watts into 2 Ohms, 1 Channel (Subwoofer)
Gain:
30.5dB
Controls and Indicators:
(Front Panel) AC Mains Power Switch
Power-on LED Indicator, Left, Center, Right, Left
Surround, Right Surround and Subwoofer Signal
Status Indicators (green active / red clip)
(Rear Panel) Ground Lift Switch.
Turn-On Delay:
3 second, solid state activated
Special Feature:
“Soft Clip” speaker protection
Cooling:
Two fans with rear to front cooling.
Crosstalk:
-80 dB
Damping Factor:
500:1 at 1 kHz
Slew Rate:
Closed-loop, greater than 40V per micro second
Frequency Response:
Plus/minus 0.25 dB
20 Hz-20kHz
Distortion:
No more than 0.1 percent THD or IM, 0.01W to
rated output, 20 Hz to 2O kHz (typically 0.01
percent)
Hum and Noise:
101 dB below rated output (unweighted, 20kHz
bandwidth)
Input Sensitivity:
Factory Selectable, .775v, 1.0v, 1.5v, shipped at
1.0v for rated output
Input Impedance:
15 kOhms nominal
Input Connectors:
One 12 position Phoenix (unbalanced)
Output Connectors:
Six 5-way binding posts; One 9 pin D-type
subminiature port
Mains Input:
2400W 30A/15A 100/240 VAC 50/60Hz
Dimensions:
Slimline 7" height, 19" standard rack mount
width, 14" depth overall (less handles)
Weight:
45 lbs. (20.51 kg)