Filter
Top Products
[ Installation ]
10
Installation
The FM Extender Antenna should be placed inside the vehicle, as close as possible to the
vehicle’s FM antenna. A test mounting should be done first using the included suction cup
mounts to test the installation. Once an acceptable location has been found, you will remove
the suction cups and permanently adhere the FM Extender Antenna using the adhesive
mounts.
To install the FM Extender Antenna in your vehicle, follow these instructions:
Attach the suction cups to the FM Extender Antenna in the positions shown in Figure 1.
Suction Cups
In this step, follow the specific instructions in sub-step a, b, c, or d depending on the
type of FM antenna in your vehicle:
a. Installation Instructions for Vehicles with Aerial Type Fender Mounted FM Antenna.
For vehicles where the FM radio antenna is located on the front fender, the FM
Extender Antenna should be mounted vertically on the front windshield at the edge
of the glass nearest to the antenna. (Figure 2)
For vehicles where the FM radio antenna is located on the rear fender, the FM
Extender Antenna should be mounted vertically on the rear window at the edge of
the glass nearest to the antenna. (Figure 3)
Clean the area where the suction cups will be mounted with the supplied alcohol
swab and attach the FM Extender Antenna to the section of glass closest to the
FM antenna in a vertical orientation. (Figure 2 or Figure 3) The wire between the
two suction cups should be pulled taut and as straight as possible, and should not
obstruct the driver’s view.
1.
2.
Figure 1Figure 1