Filter
Top Products
- 9 -
Improving the transmission quality
You can try the following measures to im-
prove the quality in event of transmission
disruptions:
Change the position and/or direction •
of the transmitter q and/or receiver d.
For problems with the remote control •
signal quality change the position of
the infrared cable's 2# transmission
diodes to the infrared receiver of the
signal source.
Try setting one of the other 4 trans-•
mission channels via the CHANNEL
switch s and l.
Channel configuration
(parallel operation)
You can operate up to 4 radio transmis-
sion sets within close proximity of each
other. Then you select, for each set, their
own channel from the 4 different avail-
able channels.
Expansion options
Expand the radio transmission set by
connecting multiple transmitters q or
receivers d.
Note:
If you want to control a receiver d
selectively with several transmitters q
you should never have several trans-
mitters switched on at the same time.
This prevents transmission disruptions.
Transmitter
Receiver
Cleaning
Risk of electric shock!
Disconnect the wall plug transformer
(1() from the mains power socket
when you want to clean the radio
transmission set.
Important!
Chemical cleansers may damage the
radio transmission set.
Clean the radio transmission set only
with a slightly damp cloth.
Troubleshooting
If a problem arises, please check the fol-
lowing table first. If the problem cannot
be resolved please contact one of the
listed service locations.
No audio/video transmission
Are the transmitter > q and receiver d
switched on?
Are the transmitter channel switch > s
and the receiver channel switch l
set to the same channel?
The range of the radio transmission >
set is reduced by walls and ceilings.
Reduce the distance between the
transmitter q and the receiver d.
IB_KH2130_DT35269_LB3C.indb 9IB_KH2130_DT35269_LB3C.indb 9 04.09.2009 13:08:58 Uhr04.09.2009 13:08:58 Uhr