Filter
Top Products
- 8 -
Open the battery compartment > g on the rear of the device.
Insert 4 x 1.5V batteries of the type "C/Baby/LR14" as per
>
the insertion markings shown in the battery compartment g.
Pay heed to the correct poling of the batteries, otherwise the
>
device will not function and could even be damaged.
Close and secure the battery compartment
> g .
Leaking batteries can cause damage to the radio. If you do
>
not intend to use the device for an extended period, remove
the batteries.
Switching the device on and o
To switch the device on, turn the > On/O switch - sound
volume regulator i clockwise over a small resistance.
Press the respective button
>
FM = Very high frequency > o,
MW = Medium wave > a,
LW = Long wave > s, or
SW = Short wave > d,
to select the desired
> frequency range .
For VHF reception, extend the telescope aerial
> q to its full
length and then determine its best positioning.
For reception of the remaining frequency ranges, the radio is
>
tted with a built-in aerial. To improve reception, if necessary
turn the radio until it is in the most favourable position.
Turn the transmitter calibration TUNING
> e to receive the
desired radio station. Use the station dial for orientation.
Select the desired sound volume using the
> sound volume
regulator i.