Shure P4R Satellite Radio User Manual


 
3
ENGLISH
Thank you for buying the P4R Receiver. The P4R is a component in the PSM
®
400 family of wire-
less personal monitors. When used with a P4T Transmitter, it provides the many advantages of a
wireless, in-ear monitoring system, including:
Improved Sound Quality
- high fidelity without the risk of feedback,
Increased Mobility
- your mix moves with you,
Personal Control
- through volume adjustment and MixMode
®
.
For further information on the PSM 400 system, see the PSM 400 Wireless Personal Performance
Pack user's guide, available on the world wide web at www.shure.com.
P4R RECEIVER FEATURES
FIGURE 1
1. Balance Knob: This thumbwheel adjusts the left/right balance when the unit is in stereo and the
mix 1/mix 2 balance when the unit is in MixMode.
2. SCROLL Pushbutton: Use with the SELECT pushbutton to control the functions in the LCD
screen. See Pushbutton Controls on page 6.
3. SELECT Pushbutton: Use with the SCROLL pushbutton to control the functions in the LCD
screen. See Pushbutton Controls on page 6.
4. 1/8" Earphone Output Jack: Connects to earphones.
5. Belt Clip: Securely attaches the receiver to a belt, guitar strap or waist band.
6. LCD Screen: The LCD screen displays the status of various functions. See LCD Screen on page 4.
7. ON/OFF/VOLUME Knob: Turn clockwise past click to turn ON. Continue to turn clockwise to
increase volume, counterclockwise to decrease volume.
8. Battery Compartment Door: See Battery Installation on page 4.
9. Antenna: An attached, flexible whip antenna receives radio frequency (RF) from the transmitter.
QUICK SET UP
1. Set up and activate a P4T transmitter according to directions in the P4T user's guide.
2. Open the battery door of the P4R receiver and insert a 9V alkaline battery, following the correct +/-
alignment. See Battery Installation on page 4.
3. Turn the ON/OFF/VOLUME knob clockwise past click (ON). Keep volume set at minimum.
4. Set the P4R to the same reception channel as the P4T. See Changing Reception Channel on
page 6.
5. Check the LCD screen to see if RF( ) is being received. See LCD Screen on page 4.
6. Plug earphones into earphone output jack.
7. Insert earphones into your ears as instructed in the earphone's user guide.
8. Increase the volume to a comfortable listening level.
9. Set the desired functions in the LCD screen. See LCD Screen on page 4, and Pushbutton Controls
on page 6.
FREQ MIX
EQ
LIM
1
2
3
4
5
6
7
8
9
P4R TOP PANEL
WARNING: High volume levels may cause hearing damage!