Shure BLX14/CVL Headphones User Manual


 
6
Batteries
Expected life for AA batteries is up to 14 hours (total
battery life varies depending upon battery type and
manufacturer).
When the LED indicator turns red, it signifies "low battery"
with approximately 60 minutes of remaining battery life.
For alkaline batteries only. For rechargeable batteries,
solid red means the batteries are dead.
To remove batteries from the handheld transmitter, push
them out through the opening in the microphone battery
compartment.
WARNING:Danger of explosion if battery
incorrectly replaced. Operate only with Shure
compatible batteries.
WARNING:Battery packs shall not be exposed
to excessive heat such as sunshine, fire, or
the like.
Wearing the Bodypack
Transmitter
Clip the transmitter to a belt or slide a guitar strap through
the transmitter clip as shown.
For best results, the belt should be pressed against the
base of the clip.
Power Off
Hold down the power button to power off the BLX2 or
BLX4/88. To power off the BLX1, slide the power toggle
switch to OFF.
Removing and Installing
Identification Caps
The BLX2 is equipped with a black identification cap from
the factory (dual vocal systems ship with additional gray
cap).
Toremove:Remove battery cover. Squeeze sides and
pull off cap.
Toinstall:Align the cap and click into place. Replace
battery cover.
An Identification Cap Kit containing assorted colored caps
is available as an optional accessory.
English