Filter
Top Products
ENGLISH
4
USING THE BETA 53 IN HARDWIRED APPLICATIONS
An in-line preamplifier (Shure part no. RPM626) may be used with the Beta 53. This
device requires phantom power ranging from 11 to 52 Vdc.
USING THE BETA 53 WITH OTHER BODYPACK TRANSMITTERS
If connecting the microphone to anything OTHER than a Shure wireless bodypack,
make sure it provides a regulated +5 Vdc source (130
mA minimum) to the red con-
ductor, as shown in Figure 1.
CONDENSER
CARTRIDGE
IMPEDANCE
CONVERTER
G
SHIELD
BLK
RED
S
D+
+5 Vdc (130 mA min.)
Audio Out
MICROPHONE WIRING DIAGRAM
FIGURE 1
USING THE BETA 53 WITH THE TA4F CONNECTOR
The following diagram shows how the Beta 53 is wired to the TA4F connector.
CONDENSER
CARTRIDGE
IMPEDANCE
CONVERTER
SHIELD
BLK
RED
+5 Vdc
Audio Out
G
D
S
1
3
4
2
TA4F (solder side view)
TA4F CONNECTOR WIRING DIAGRAM
FIGURE 2