Sherwood ST-4108 Speaker User Manual


  Open as PDF
of 6
 
Troubleshooting Guide
6
Specifications
No Power
No sound
Distorted sound
Less bass and poor
imaging
The AC input cord is disconnected.
The POWER switch on the rear panel is
not pressed.
Incorrect connection between the
components.
Incorrect operation of the component
connected.
The unit runs at excessively high volume
level.
The PHASE switch is set to the opposite
position.
Connect the cord securely.
Turn the POWER knob to ON.
Make connections correctly.
Operate the component correctly.
Decrease the volume level.
Set the PHASE switch correctly.
PROBLEM POSSIBLE CAUSE REMEDY
ASW-4108
Frequency Response 45~300Hz
Power, Impedence 4 75 W
Sound Pressure Level 80dB/W/m
Power Supply 120V/60Hz
Power Consumption 75W
ST-4108F/R
RMS Power 35W
Max Power 70W
Impedence 6
Power Pressure Level 86dB/W/m
ST-4108C
RMS Power 35W
Max Power 70W
Impedence 6
Power Pressure Level 86dB/W/m
Note : Specifications are subject to change without notice.
If this unit does not perform as expected, consult the table below to see if the problem can be corrected before
seeking help from your dealer or our service organization.
 previous