Filter
Top Products
6
Manufactured under license from Digital Theater Systems, Inc.
US Pat. No. 5,451,942 and other world-wide patents issues and pending.
“DTS” and “DTS Digital Surrou of Digital Theater Systems, Inc.
©1996 Digital Theater Systems, Inc. All rights reserved.
Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic”
and the double-D symbol are trademarks of Dolby Laboratories. Confidential
Unpublished Works. ©1992-1997 Dolby Laboratories, Inc. All rights reserved.
AUDIO/VIDEO RECEIVER
MADE IN CHINA
DESIGNED IN USA
SWITCHED
120V~60Hz
100W 1A MAX
AC OUTLET
OPTICAL
COAX 1 COAX 2
AC INPUT
120V~60Hz
180W
SER. NO
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:"SHOCK HAZARD-DO NOT OPEN"
AVIS;"RISQUE DE CHOC-ELECTRQUE-NE PAS OUVRIR"
AM
LOOP
FM
75
Ω
ANTENNA
AUX PLAY REC PLAY REC PLAY VIDEO 1
VIDEO 2
SUB
WOOFER
TAPE MON. VIDEO 1
CD
VIDEO 2
MONITOR
PRE OUT
VIDEO
OUT
DIGI
-LINK
VIDEO
IN
VIDEO 1
SUB
WOOFER
CENTER
FRONT REAR
L
R
6
-
CH DIRECT INPUT
L
R
■ CONNECTING DIGITAL INPUTS
• The COAXIAL or the OPTICAL DIGITAL Out's of
the components that are connected to CD, VIDEO 2
and VIDEO 3 of this unit can be connected to these
DIGITAL INPUTS.
• A digital input should be connected to the components
such as a CD player, LD player, DVD player, etc. that
are capable of outputting a signal in the DTS, Dolby
Digital or PCM digital formats.
• For details, please refer to the operating instructions of
the component to be connected.
• When making COAXIAL DIGITAL connections use
75 Ohm Cable. Do not use standard audio patch cords.
• Not all of the commercially available Fiber Optic
cables are suitable for use with this receiver. If you
have a question as to the suitability of any cable,
please check with your dealer or a qualified service
organization.
• Remove the protective cap before making nay
OPTICAL connections. Reinsert the protective cap
when not using the OPTICAL Jacks.
• The speaker terminals are designed to accept either bare wire or
banana plugs.
• If using bare wire, take care to not allow the + and - wires to touch
or short.
• Connect the speaker wires firmly and correctly according to the
channel and position. Observe the proper polarity (+ and -).
• This receiver is designed for use with speakers rated at 6 ohms
impedance or above.
■ CONNECTING SPEAKERS
Front right
Front left
Rear left
Powered subwoofer
■
SUBWOOFER PRE OUT connection
• To emphasize the deep bass sound, connect a powered
subwoofer.
L
R
Rear right
Center
SUB
WOOFER
PRE OUT
OPTICAL
COAX 1 COAX 2
DIGITAL IN
Component with
COAXIAL DIGITAL OUT
Component with
COAXIAL DIGITAL OUT
Component with
OPTICAL DIGITAL OUT
MODEL NO. RD
-
7103
DIGITAL IN
EENNGGLLIISSHH