Filter
Top Products
ENGLISH
16
Operations
LISTENING TO A PROGRAM SOURCE
Before operation
• Push the POWER switch.
• This unit enters the standby mode and the POWER
ON/STANDBY button lights up amber.
This means that the receiver is not disconnected from the
AC mains and a small amount of current is retained to
support the operation readiness.
• To switch the power off, push the POWER switch again.
Then the power is cut off and the POWER ON/STANDBY
button goes off.
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode(the POWER ON/STANDBY button lights
up blue) or off to enter the standby mode(the POWER
ON/STANDBY button lights up amber).
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
• You can select the various combinations of speakers
depending on where the speakers C or/and D are
installed.
• Each time the SPEAKER A/B SELECTOR button on the
front panel is pressed, the speakers are switched on or off
as follows:
A/B ~ - /- ~ A/ - ~ - /B ~
or (MAIN A/B) or (MAIN -/-) or (MAIN A/-) or (MAIN-/B)
( ): When the ROOM2 mode is set to on.
• Each time the SPEAKER C/D SELECTOR button on the front panel is pressed, the speakers are switched on or off as
follows:
~C/D ~ - / - ~ C/ - ~ - / D
or (R2 C/D) or (R2 -/-) or (R2 C/-) or (R2 -/D)
( ): When the ROOM2 mode is set to on.
• When using the headphones for private listening, switch off all the speakers installed in the main room.
Note: To use ROOM2 function, you should install speakers C or/and D in another room (ROOM2) and set the ROOM2
mode to on.(For details, refer to “CONNECTING SPEAKERS” on page 6 and “ROOM2 PLAYBACK” on page 24.)
or
or
1. In the standby mode, turn the power on.
2. Switch the desired speakers on.