Sherwood RX-5502 Stereo System User Manual


 
11
LISTENING TO A PROGRAM SOURCE
Operations
• Each time the ON/STANDBY button on the front
panel, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
1. In the standby mode, turn the power on.
• This unit enters the standby mode and the
STANDBY indicator lights up.
This means that the receiver is not disconnected
from the AC mains and a small amount of current is
retained to support the operation readiness.
• To switch the power off, push the POWER switch
again. Then the power is cut off and the STANDBY
indicator turns off.
Before operation
Push the POWER switch.
2.
Switch the desired speakers on.
• You can select the various combinations of
speakers depending on where the speakers C or/
and D are installed.
• Each time the SPEAKER A/B SELECTOR button is
pressed, the speakers are switched on or off as
follows :
A/B ~ - / - ~ A/ - ~ - /B ~
or (MAIN A/B) or (MAIN -/-) or (MAIN A/-) or (MAIN -/B)
( ) : When the ROOM2 mode is set to on.
• Each time the SPEAKER C/D SELECTOR button
is pressed, the speakers are switched on or off as
follows :
~ C/D ~ - / - ~ C/ - ~ - /D
or (R2 C/D) or (R2 -/-) or (R2 C/-) or (R2 -/D)
( ) : When the ROOM2 mode is set to on.
• When using the headphones for private listening,
switch off all the speakers installed in the main
room.
Note :
• To use ROOM2 function, you should install
speakers C or/and D in another room (ROOM2)
and set the ROOM2 mode to on. (For details, refer
to "CONNECTING SPEAKERS" on page 7 and
"ROOM2 PLAYBACK" on page 19.)
RX-5502(A) 2007.5.17 9:15 AM 페이지 11