Filter
Top Products
9
ENGLISH
Operations
• To use the system remote control unit of Sherwood system receiver RX-801R, first connect the SYSTEM
CONNECTOR jack of this unit to that of RX-801R.(Refer to the operating instructions of the RX-801R.)
PLAYING BACK A TAPE
In case of the tape recorded with Dolby
B NR system, select the Dolby B NR
mode.
3
Select the desired reverse mode.
4
• Each time the POWER(ON/STANDBY) button is
pressed, this unit is turned on or off.
• Each time this button is pressed, the Dolby B NR
mode changes as follows:
DOLBY B NR(“B” light up) OFF
• On the commercial tapes, if Dolby NR or “ ”
appears, the tapes are recorded with the Dolby B
NR.
• Each time this button is pressed, the reverse mode is
selected as follows:
Start playback.
5
Turn the power on.
1
ON/STANDBY
SLEEP
EDIT
AUTO/MONO
TUNING TUNE MODE
PROGRAM
MUTE
TIMER
VOL
VOL
AUX
MD
TUNER
TAPE
CD
POWER
123
456
789
0
MEMO ENTER
DOLBY C.RESET
TIME REPEAT
RANDOM
CD SYNC.
REV.MODE
EON
RDS
REMOTE CONTROL UNIT
RM-404
SYSTEM REMOTE
CONTROL UNIT
(only for RX-801R)
DISPLAY
REV.MODE
SLEEP
EDIT
AUTO/MONO
TUNING TUNE MODE
PROGRAM
MUTE
TIMER
VOL
VOL
AUX
MD
TUNER
TAPE
CD
POWER
123
456
789
0
MEMO ENTER
DOLBY C.RESET
TIME REPEAT
RANDOM
CD SYNC.
REV.MODE
EON
RDS
REMOTE CONTROL UNIT
RM-404
SYSTEM REMOTE
CONTROL UNIT
(only for RX-801R)
DISPLAY
DOLBY
SLEEP
EDIT
AUTO/MONO
TUNING TUNE MODE
PROGRAM
MUTE
TIMER
VOL
VOL
AUX
MD
TUNER
TAPE
CD
POWER
123
456
789
0
MEMO ENTER
DOLBY C.RESET
TIME REPEAT
RANDOM
EON
RDS
CD SYNC.
REV.MODE
REMOTE CONTROL UNIT
RM-404
DISPLAY
TAPE
or
Back side Front side
SYSTEM REMOTE
CONTROL UNIT
(only for RX-801R)
: Playback of a single side.
: Repeat playback of both sides.
( Front side Back side )
: Playback of both sides.
(Front side Back side)
Load a tape.
2
• According to the type of the tape loaded, the
corresponding type(normal, chrome) is detected by
the auto tape selector.
Note: Do not open or close the tape tray by force.
Doing so may damage it.
OPEN/CLOSE
• Each time “TAPE ” button pressed, the
corresponding side is played back.
• At the end of the tape, according to the reverse
mode, the playback of the next side starts or the
playback of the current side stops automatically.