Filter
Top Products
11/8/3 01_XLDAB151PH EN_AUS.fm
6
System connections
Supplied DAB/FM aerial:
Connect the DAB/FM aerial wire to the DAB/FM terminal
and position the DAB/FM aerial wire in the direction where
the strongest signal can be received.
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
● The first time the unit is plugged in, the unit will enter
the demonstration mode.
● To cancel the demonstration mode, press the DEMO/
DIMMER button (remote control) during power stand-
by mode. The unit will enter the low power consumption
mode.
● If iPod or iPhone is docked, the unit will begin charging.
“Charge Mode” will be displayed. Demonstration mode
is invalid during charge mode.
● To return to the demonstration mode, press the DEMO/
DIMMER button again.
Photo and video files from iPod or iPhone can be viewed
by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket at the back of the unit and set the TV Out on
the iPod or iPhone unit to “ON” position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple’s homepage for
further information.
Make sure to unplug the AC power lead before making any connections.
MADE IN CHINA
SERIAL NO.
MODEL NO.
XL-DAB151PH(S)
HI FI COMPONENT SYSTEM
AC 220 - 240V 50/60Hz 45W
FREQUENCY RANGE : FM 87.5 - 108 MHz
DAB 174.928 - 239.200 MHz
92Lxxxxxxxxxxx
Right
speaker
DAB/FM aerial
To video input socket
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Video cable
(not supplied)
RED
BLACK
Left
speaker
TV
Label is located at the
bottom of the unit.
■ Aerial connection
■ Speaker connection
● Connect the black wire to the
minus (–) terminal, and the red
wire to the plus (+) terminal.
● Use speakers with an impedance
of 4 ohms or more, as lower
impedance speakers can damage
the unit.
● Do not mistake the right and the
left channels. The right speaker is
the one on the right side when you
face the unit.
Incorrect
● Do not let the bare speaker wires touch each other.
● Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
● Do not stand or sit on the speakers. You may be
injured.
■ Demonstration mode
■ Connecting iPod or iPhone to TV