Filter
Top Products
02/9/11 XL35H_H_E3.fm
E-22
ENGLISH
XL-35H
8
7
6
5
4
3
2
1
References
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a
service technician.
If something is wrong with this product, check the following before calling
your authorised SHARP dealer or service centre.
"
General
"
CD player
"
Tuner
"
Cassette deck
"
Remote control
Symptom Possible cause
The clock is not set
to the correct time.
!
Did a power failure occur? Reset the clock (re-
fer to page 9).
When a button is
pressed, the unit
does not respond.
!
Set this unit to the power stand-by mode and
then turn it back on.
!
If the unit still malfunctions, reset it. (Refer to
page 23.)
No sound is heard.
!
Is the volume level set to "MIN"?
!
Are the headphones connected?
!
Are the speaker wires disconnected?
Playback does not
start.
!
Is the disc loaded upside down?
Playback stops in
the middle or is not
performed properly.
!
Does the disc satisfy the standards?
!
Is the disc distorted or scratched?
Playback sounds
are skipped, or
stopped in the mid-
dle of a track.
!
Is the unit located near excessive vibrations?
!
Is the disc very dirty?
!
Has condensation formed inside the unit?
The radio makes un-
usual noises continu-
ously.
!
Is the unit placed near the TV or computer?
!
Is the FM or AM aerial placed properly?
Move the aerial away from the AC power
lead if located near.
Cannot record.
!
Is the erase-prevention tab removed?
Cannot record tracks
with proper sound
quality.
!
Is it a normal tape? (You cannot record on a
metal or CrO tape.)
Cannot erase com-
pletely.
Sound skipping.
!
Is there any slack?
Cannot hear treble.
!
Is the tape stretched?
Sound fluctuation.
!
Are the capstan, pinch roller, or heads dirty?
Cannot remove the
tape.
!
If a power failure occurs during playback, the
heads remain engaged with the tape. Do not
open the compartment forcibly. Wait until
electricity resumes.
The remote control
does not operate.
!
Is the AC power lead of the unit plugged in?
!
Is the battery polarity correct?
!
Are the batteries dead?
!
Is the distance or angle incorrect?
!
Does the remote control sensor receive
strong light?