Sharp MD-MX20 Stereo System User Manual


 
32
TIMER OPERATION
Timer playback/Timer recording
6 Turn the jog dial to set the minute to start, and then
press the MEMORY/ENTER button.
I If the ending time is not set manually, it will automatically
be set for one hour after the starting time.
7 Turn the jog dial to set the hour to stop, then press
the MEMORY/ENTER button.
8 Turn the jog dial to set the minute to stop, then press
the MEMORY/ENTER button.
REC
PLAY
or
9 Adjust the VOLUME control for the desired volume.
Be careful not to turn the volume up too high.
10 Press the ON/STAND-BY button to enter the stand-
by mode.
The TIMER indicator will light up.
11 When the timer start time is reached, timer playback
or timer recording will start.
12 When the timer end time is reached, timer recording
will stop.
Notes:
I The timer cannot control the component connected to the
auxiliary input jacks.
I When the CD or MiniDisc is played to the end, playback
will stop before the stop time.
If you wish to play to the stop time, set repeat play for the
CD or MiniDisc.
Timer playback and timer recording cannot be set at the
same time using the timer.
I Before setting the timer, make sure that the clock setting
is correct (page 11).
1,10
Jog dial
32 MD
HH
HH
H
9
2 CD
HH
HH
H
2 TUNER (BAND)
MEMORY/
ENTER
TIMER
2 AUX
Before timer operation, the following preparations are required.
Load a CD and a recordable MiniDisc for timer recording or
Preset the radio station that you want to record from or
listen to during timer playback.
1 Press the ON/STAND-BY button to turn the power on.
2 (To select timer playback source)
Press the CD , MD , TUNER (BAND) or AUX button.
(To select timer recording source)
Press the CD , TUNER (BAND) or AUX button.
3 (To select timer playback)
Press the TIMER/DELETE button to select the timer
playback mode.
PLAY
(To select timer recording)
Press the TIMER/DELETE button again to select the
timer recording mode.
REC
4 While "
ff
ff
f PLAY" or "
ff
ff
f REC" is flashing, press the
MEMORY/ENTER button.
5 Turn the jog dial to set the hour to start, and then press
the MEMORY/ENTER button.