Filter
Top Products
<P=002>
HEADPHONES
● Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
● Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance. The
recommended impedance is 32 ohms.
● When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
RESETTING THE MICROCOMPUTER
Reset the microcomputer under the following conditions:
● To erase all of the stored memory contents (clock and timer
settings, and tuner and CD presets).
● If the display is not correct.
● If the operation is not correct.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 While pressing down the button and the EQUALIZER/X-
BASS/DEMO button, hold down the ON/STAND-BY button for
at least 1 second.
● "CLEAR AL" will appear.
Caution:
● The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
TRANSPORTING THE UNIT
Before you move this product to a new location, proceed
as follows:
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD button.
3 Press the OPEN/CLOSE button to open the disc tray.
● Remove all CDs inserted in the unit.
4 Press the OPEN/CLOSE button to close the disc tray.
● Make sure that "NO DISC" is displayed.
5 Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power cord from the AC outlet.
CD
OPEN/
CLOSE
POWER
ON/
STAND-BY
EQUALIZER
X-BASS/
DEMO
POWER
ON/
STAND-BY
CD-BA120(SEC) TINSE0299AWZZ
15