Filter
Top Products
03/12/19 CD-SW300 26-33.fm
29
CD-SW300
Radio
Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few hours
should there be a power failure or the AC power cord become discon-
nected.
To recall a memorized station
To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
To erase entire preset memory
1
Perform steps 1 - 3 in "Tuning" on page 28.
2
Press the MEMORY button to enter the preset tuning sav-
ing mode.
3
Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorized, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorized for that preset channel number will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to se-
lect the desired station.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired sta-
tion is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 While pressing down the button and the button, press
the TUNER (BAND) button until "TUNER CL" appears.