Filter
Top Products
12/10/26 12_GX-M10H_OM_EN.fm
E-18
EN
Connecting other equipment
The connection lead is not included. Purchase a
commercially available lead as shown below.
Caution:
Be careful not to connect a bass guitar as it might damage
this unit.
Note:
To prevent noise interference, place the unit away from the
television.
● Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
● Before plugging in or unplugging the headphone,
reduce the volume.
● Be sure your headphone has a 3.5 mm (1/8") diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
● Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
■ Connecting a guitar / microphone
1
Set the guitar/microphone volume (GAIN) knob to the
minimum level.
2 Connect a guitar/microphone to the correct input socket.
Make sure that the cable has a 6.3 mm (1/4") diameter
plug.
3
Arrange the guitar/microphone cables into the grooves
of the cable holder on the left or the right side of the unit.
Then, thread the cable through the bottom of the unit.
Do not let the cables to be on top of the unit when
using guitar/microphone as it may cause the unit to
roll over causing damage and injury.
4 Connect the cables to a guitar/microphone.
5 Select a source.
● To mix a guitar or microphone sound with a source
sound, select the playback source (iPod/CD/USB/
Audio In/Tuner).
● To play a guitar or using the microphone only, select
’AUDIO IN’ function. Make sure there is no playback
from Audio In connection.
6 Adjust the volume (GAIN) knob on the connected
equipment.
Note:
Before disconnecting the guitar/microphone, set the guitar/
microphone volume (GAIN) knob to the minimum level.
Microphone or
guitar (not supplied)
? 6.3 mm monaural
cable (not supplied)
Cable holder
Thread the cables under the unit
■ Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and the
video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUDIO IN button on the remote control or
TUNER/AUDIO IN button repeatedly on the main unit to
select AUDIO IN function.
4 Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase the
volume of the connected device.
■ Headphones
Audio cable (not supplied)
Portable audio
player, etc.
Headphone
(not supplied)