Filter
Top Products
E-4
System connections
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
● The first time the unit is plugged in, the unit will enter
the demonstration mode.
● To cancel the demonstration mode, press the DEMO/
DIMMER button (remote control) during power stand-
by mode. The unit will enter the low power consumption
mode.
● If iPod or iPhone is docked, the unit will begin charging.
“Charge Mode” will be displayed. Demonstration mode
is invalid during charge mode.
● To return to the demonstration mode, press the DEMO/
DIMMER button again.
Photo and video files from iPod or iPhone can be viewed
by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket at the back of the unit and set the TV Out on
the iPod or iPhone unit to “ON” position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple’s homepage for
further information.
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
Make sure to unplug the AC power lead before making any connections.
Right
speaker
FM aerial
To video input socket
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Video cable
(not supplied)
Red
Left
speaker
TV
■ Aerial connection
■ Speaker connection
●
For XL-HF201P(S)/(BK) –
Connect
the black wire to the minus (–)
terminal, and the red wire to the
plus (+) terminal.
●
For XL-HF301P(S) –
Connect the
wire without insulation tube to the
minus (–) terminal, and the wire with
red insulation tube to the plus (+)
terminal.
Incorrect
● Connect the wire without insulation tube to the minus (–
) terminal, and the wire with red insulation tube to the
plus (+) terminal.
● Use speakers with an impedance of 4 ohms or more, as
lower impedance speakers can damage the unit.
● Do not mistake the right and the left channels. The right
speaker is the one on the right side when you face the
unit.
● Do not let the bare speaker wires touch each other.
● Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
● Do not stand or sit on the speakers. You may be
injured.
■ Demonstration mode
■ Connecting iPod or iPhone to TV
■ AC power connection