Filter
Top Products
17
06/2/14 CD-G20000_E2.fm
TINSEA128AWZZ
Preparation for Use
CP-G20000S
CD-G20000
Subwoofer control
Power switch
Press the POWER ON/OFF button to turn ON the Active Subwoofer.
Volume control
Turn the VOLUME control clockwise to increase the volume, and turn
it counterclockwise to decrease the volume.
Crossover frequency control
Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasize the bass, turn this control toward 35 Hz and increase
the volume.
Speaker light up
The speaker unit surface will light up and blink according to BASS
SOUND LEVEL.
During STANDBY MODE (DEMO MODE):
When subwoofer is turned ON, the subwoofer unit will emit blinking
light.
During STANDBY MODE (low power consumption mode):
When subwoofer is turned ON, no light will be emitted from the
subwoofer unit.
Notes:
Observe the following to avoid malfunction and sound distortion.
Do not set the volume too high on the main unit. The subwoofer
may be damaged.
Before you switch on/off on the main unit, minimize the volume on
the main unit.
Unplug the AC power cord when connecting the subwoofer cable.
Before you turn the system on/off on the main unit, minimize the
speaker volume on the main unit and turn the VOLUME control of
the subwoofer to "–".