Filter
Top Products
Wireless RS 60-9
English
Charging the accupack
For charging the accupack, place the
headphones into the transmitter’s charging
compartment (nb: make sure the headphones
are inserted the correct way round. The
Sennheiser logo on the headband must be
readable looking from the front - see diagram.
The charging contacts are on the RH earpiece
of the headphones - these are placed on the
corresponding contacts in the LH indentation of
the transmitter, the one next to the “charge” light). The red LED on the transmitter
must light up to show charging is taking place.
Always store the headphones on the transmitter to ensure that they are fully
charged when they are needed. The headphones are automatically switched off
by the charging process.
BA 151 spare accupack
When the headphones’ accupack is going flat (noise, interference and distortion
are sure signs of a flat accupack), recharge the accupack. After an initial charging
of 24 hours, the normal charging time is 14 hours. A fully charged accupack has
an operating time of approx. four hours. Place the discharged accupack in the
charging compartment at the back of the transmitter and use the spare accupack
in the meantime.
Additional BA 151 spare accupacks can be charged via the L 151-2 charger
(available from your specialist dealer).
Before disposing of an old and exhausted accupack, make sure that it is totally
discharged by using it until the device switches off. To protect the environment,
only dispose of totally exhausted accupacks.
Sound Retrieval System (SRS)
This device is equipped with SRS, a system that creates a full bodied three
dimensional sound image from a stereo signal. You can switch SRS
ON and OFF
by pressing the S
URROUND button on the transmitter.
Additional information
The audio transmission technology used with this device is basically that of a
radio. According to today’s scientific knowledge, the radio waves emitted by this
device are not harmful to humans or animals.
ATTENTION: LISTENING AT HIGH VOLUME LEVELS FOR LONG
PERIODS CAN PERMANENTLY DAMAGE YOUR HEARING.
This device has been designed for use with stereo devices. For connection to
mono devices, please use a stereo to mono jack plug available from most audio
accessory shops.
Use a soft cloth or, if necessary, a damp wash-leather for cleaning the devices. Do
not use aggressive cleansing agents.
is a trademark of SRS Labs, Inc.