Filter
Top Products
23
Care and maintenance
Cleaning the transmitter
̈ Before cleaning, disconnect the transmitter from the mains.
̈ If necessary, you can clean the transmitter with a slightly
damp cloth. Do not use any cleansing agents or solvents.
Replacing the fuse
̈ Disconnect the transmitter completely from the mains by
pulling out the mains connector from the wall socket.
̈ Use a screwdriver to loosen the fuse holder ¸.
̈ Remove the fuse holder with the inserted fuse.
̈ Replace the fuse by a new fuse with the same rating.
̈ Reinsert the fuse holder. Make sure to insert the fuse holder
the correct way round.
The set voltage is shown at the top of the fuse holder.
̈ Reconnect the transmitter to the mains and and switch it on
again.
Water can damage the electronics of
the transmitter!
Water entering the housing of the transmitter
can cause a short-circuit and damage the
electronics.
̈ Only use a slightly damp cloth to clean the
transmitter.
Electric shock hazard!
In case of improper handling, you may come into
contact with electrically conducting parts and
receive an electric shock when removing the
fuse holder.
̈ Before removing the fuse holder, pull out the
mains connector from the wall socket.
CAUTION!
WARNING!