Filter
Top Products
Using the transmitter
15
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output ·.
̈ Set the headphone volume control » to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ·.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Synchronizing transmitters and EK 2000 IEM receivers via the
infra-red interface
Synchronization allows you to quickly and easily transfer transmitter and receiver settings
from one device to the other, especially if you want to configure a multi-channel system.
There are two transfer directions:
1. Easy Setup Sync: Transfer from the receiver to one or several transmitters
Once you have performed a frequency preset scan with your receiver, you can use the
Easy Setup Sync function to transfer unused frequency presets from the receiver to the
transmitters via the infra-red interface. In order to configure a multi-channel system, you
use the diversity receiver to transfer the first unused channel from the selected frequency
bank to the first transmitter and the next unused channel to the second transmitter and
so on, thus ensuring that all transmitters of a multi-channel system operate on suitable
frequencies.
2. Sync: Transfer from a transmitter to a receiver
Once you have selected and set the desired receiver settings on the transmitter (either
manually or using the Easy Setup Sync function), you transfer these settings to a receiver.
This configures the receiver and establishes a transmission link between transmitter and
receiver.
Via the “Sync Settings” submenu, you can adjust the receiver parameters listed below and
activate or deactivate their transfer to an EK 2000 IEM receiver.
During mono operation, you have to deactivate the pilot tone evaluation on the
EK 2000 IEM receiver in order to ensure that your receiver outputs the same signal
on channel I and II.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the headphone volume control » to the minimum position before putting the head-
phones on.
Stereo Transmitter SR 2000 IEM
PEAK
-10
0
-20
-30
-40
PEAK
-10
0
-20
-30
-40
AF I
AF II
ᕢ ᕣ
Setting Transferred receiver parameter
“Balance” Current balance setting (“−15”/“+15”)
“Squelch” Current squelch setting (“Off”, “5 dB” ... “25 dB”)
“Mode” Current audio mode setting (“Stereo”/“Focus”)
“High Boost” Current treble boost setting (“flat”/“High boost”)
“Auto Lock” Current lock mode setting (“active”/“inactive”)
“Limiter” Current limiter setting (“−18 dB”, “−12 dB”, “−6dB”, “Off”)