Filter
Top Products
Putting the RS 220 into operation
RS 220 | 13
Integrating the transmitter into an existing connection between devices
To integrate the transmitter into an existing connection between your
audio source and an additional device. By way of example of an amplifier
as an additional device, this chapter describes how to integrate the trans-
mitter into an existing connection.
̈ Pull out the plug of the audio cable from the desired input (“IN”) on the
amplifier.
̈ Connect this plug to a suitable input (“IN”) on the transmitter (see
page 7).
̈ Connect an additional identical audio cable to the output (“OUT”) on
the transmitter and to the input (“IN”) on the amplifier.
To keep the digital connection up even when the transmitter is switched
off:
̈ Switch the loop through mode on (see page 17).
The analog connection (RCA/SCART/headphone socket) is kept up
when you disconnect the transmitter from the mains.
The digital connection (coaxial/optical) is interrupted in this case.
DC IN
5V/1A
IN OUT
IN OUT
COAXIAL
OPTICAL
DIGITALANALOG
R
L
Pairing
-LEVEL
DC IN
5V/1A
IN OUT
IN OUT
COAXIAL
OPTICAL
DIGITALANALOG
R
L
Pairing
-LEVEL
DC IN
5V/1A
IN OUT
IN OUT
COAXIAL
OPTICAL
DIGITALANALOG
R
L
Pairing
-LEVEL