42
In case of difficulty
If problems occur that are not listed in the below table, please contact your Sennheiser
agent.
Possible cause and what to do
You are using a stereo intercom system but the headset is set to mono operation.
Ǡ Set the Mono/Stereo switch to ‘Stereo’.
You are receiving a mono source but the headset is set to stereo operation.
Ǡ Set the Mono/Stereo switch to ‘Mono’.
The volume control is set too low.
Ǡ Check the volume setting of the headset.
The headphone connection has been pulled out.
Ǡ Check to see if the headphone jack plug is correctly connected.
The microphone connection has been pulled out.
Ǡ Check to see if the microphone jack plug is correctly connected.
Problem
Communications in one ear only
(HME 100 only)
Very low volume communication
Reduced intelligibility