Filter
Top Products
8
Inserting and removing the receiver’s rechargeable
battery
̈ Insert the battery into the compartment ᕢ as shown on the
left. Make sure that the battery is inserted correctly.
̈ To remove the battery, use the finger catch projection to pull
the battery out of the receiver.
Note:
y The receiver is delivered with the battery inserted.
y Before you use the rechargeable battery for the first time,
charge it until the LED µ lights up green (see “Storing and
charging the receiver” on page 11).
This can take a
maximum of 3 hours.
Inserting a spare rechargeable battery into the
transmitter’s charging compartment
You can charge a spare battery (not included) in the charging
compartment ᕨ at the side of the transmitter. This spare
battery is not required for operating the IS 410 but offers
extended listening time while the discharged first battery is
being recharged.
̈ Insert the spare battery into the charging compartment ᕨ
as shown on the left.
̈ If the battery is inserted correctly, the LED ᕩ lights up
ᕢ
º
¾
red: The rechargeable battery is being charged.
green: The rechargeable battery is fully charged.