Filter
Top Products
6
Using the HDI 830
Setting the receiver to the frequency of the
transmission system
You can set the receiver to the frequency of the transmission system
yourself or have the frequency preset by your Sennheiser partner.
To set a frequency on the receiver:
Note:
The channel indicator
1 goes off after 30 seconds.
To set a fixed frequency and to deactivate the channel selection
button
4:
̈ Contact your Sennheiser partner.
Adjusting the balance
̈ Put the receiver on.
̈ Press the channel selection button
4
until you have found the frequency of
your transmission system.
On the receiver, the channel indicator
1
can light up as follows:
Channel indicator lit Frequency You hear the sound in
2.3+2.8 MHz stereo
2.8 MHz mono
The balance control allows for right/left
balance adjustment. Adjust the balance so
that you can hear equally well with both ears.
̈ Turn the balance control
3 to the left L or
right R to increase the volume for the corre-
sponding ear.
4
1
3