Filter
Top Products
14
Adjusting settings via the operating menu
Adjusting settings via the operating
menu
The main menu “Menu”
Synchronizing a transmitter with the diversity receiver – “Sync”
You can synchronize a suitable transmitter of the ew 100 G3 series with
the diversity receiver. During synchronization, the following parameters
are transferred to the transmitter:
• Current receiving frequency (“Frequency Preset”, see page 15)
• Current name set for the receiver (“Name”, see page 16)
• Current pilot tone setting of the receiver (“Pilot Tone”, see page 18)
To transfer these parameters:
̈ Switch the transmitter and the diversity receiver on.
̈ On the receiver, call up the “Sync” menu item.
“Sync” appears on the display panel of the receiver.
̈ Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface of the
receiver ¸.
The parameters are transferred to the transmitter. When the transfer
is completed, “ ” appears on the display panel of the diversity
receiver. The receiver then switches back to the current standard
display.
To cancel the transfer:
̈ Press the ON/OFF button ¹ on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was
canceled after 30 seconds,
– you canceled the transfer.
Adjusting the squelch threshold – “Squelch”
Adjustment range: “Low”, “Middle”, “High”, can be switched off
The squelch eliminates annoying noise when the transmitter is switched
off or when there is no longer sufficient transmitter power received by the
receiver.
̈ Adjust the squelch threshold – with the transmitter switched off – to
the lowest possible setting that suppresses hissing noise.
¸
Menu
Low
Squelch
Call up “Squelch” Select the
desired setting
Store the setting
“Stored”
SET
SET
Squelch Squelch
Low High