Filter
Top Products
11
Putting the AC 3200 into operation
Connecting the mains cable
̈ Connect the suitable mains cable to the IEC mains socket ²
and to the mains.
Note:
The AC 3200 can be connected to any mains power supply
with 100 V to 240 V AC (50 to 60 Hz).
Switching the AC 3200 on and off
̈ Press the on/off switch ´.
The AC 3200 switches on and the LED ¿ lights up red.
̈ Press the on/off switch ´ again.
The AC 3200 switches off and the LED ¿ goes off.
Note:
After switch-off, the AC 3200 is in standby mode. To
disconnect the device from the mains, pull out the mains
connector from the wall socket.
RF indicators
The AC 3200 has eight control LED » which light up on the
channels where transmission power is available.
70 W
¶ ¶ ¶ ¶
70 W
ᕦ
» ¿
´