Filter
Top Products
14
ENGLISH
Turning the transmitter on and off (Fig. 5)
Turn on the sound source. This automatically activates the
transmitter and the green LED “ON/OFF” lights up. If the sound
source is turned off, the transmitter is automatically deactivated
after approx. 3 minutes (the LED “ON/OFF” goes off).
Note: The automatic level control only functions if the volume of the
sound source is sufficient.
Turning the headphones on and off (ON/OFF, Fig. 5)
Move the “ON/OFF” switch on the headphones to the position “ON”.
The headphones then start the transmitter search-tuning.
Adjusting the volume (VOLUME, Fig. 6)
Use the “VOLUME” control to adjust the volume on the headphones.
Adjusting the balance (BALANCE, Fig. 6)
Use the “BALANCE” control to adjust the volume of the right and left
channels. There is a click-stop in the center position.
Auto-tuning – automatic transmitter search-tuning with
memory function
(TUNE, Abb. 7)
Note: The transmitter must be activated (green LED “ON/OFF” lit)
and the headphones must be turned on.
By pressing the TUNE button or after turn-on, the headphones start
scanning the whole frequency range for a transmitter signal. If a
transmitter signal is found, the transmitter search-tuning stops and
the audio transmission starts.
If, for some reason, the signal found is not the correct one (e.g. from
another nearby system), press the TUNE button again and the
transmitter search-tuning is continued. When turning on the head-
phones, they automatically start the transmitter search-tuning on
the last selected channel.
If no transmitter signal is received for an extended period of time
(e.g. the range is exceeded or the transmitter is deactivated), six
short beeps are produced. After approx. 10 minutes, the
RS140_GB.fm Seite 14 Dienstag, 25. Oktober 2005 5:38 17