Filter
Top Products
15
5 Align the mounting tabs with the screw holes.
Tighten the screws; do not overtighten.
6 Connect to your TV and VCR.
7 Connect your cable input from the wall.
8 Connect any additional devices, if applicable.
9 Do you have other devices to connect?
• If yes, see page 9 to locate other connec-
tion diagrams appropriate for your system.
• If no, plug in the power cord to an AC
power outlet.
Optional Devices, continued
Activating and Deactivating RF Bypass
If your remote control includes a Bypass key, follow these
instructions to use the Bypass feature.
To activate the Bypass feature, press the Bypass
key. The Bypass indicator illuminates on the DHCT.
Notes:
• You can only view analog channels; digital channels are
not available while the Bypass feature is active.
• Use the Bypass key to toggle the feature on and off.
To deactivate the Bypass feature:
1. Press the Bypass key on the remote control. The Bypass
indicator no longer illuminates on the Explorer DHCT.
2. Tune your TV using one of the following methods:
• If the TV/VCR switch on your VCR is in the VCR
position, you must tune your TV to the VCR output
channel (channel 3 or 4). You can view a tape, or you
can view the channel to which the Explorer DHCT is
tuned.
• If the TV/VCR switch on your VCR is in the TV
position, you must tune your TV to the Explorer
DHCT output channel (channel 3 or 4). You can only
view programs from the Explorer DHCT, regardless
of what your VCR is playing.
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
CAUTION
CABLE
OUT
CABLE IN
BYPASS
120 VAC
60Hz 40W
120 VAC
60Hz 5A
CABLE COMMUNICATIONS
LISTED
14141
C
VCR
T8620
IN FROM
ANT.
OUT TO
TV
TV
CABLE/
ANTENNA
Cable Input
From Wall
Bypass Module Attached to
EXPLORER DHCT
CABLE
INPUT
FROM
VCR
TO
TV
MODEL E2051-X01
7
6
5