Filter
Top Products
Rack LCD Console User Manual2
Safety
Read and adhere to the following important safety considerations when working with the Rack LCD
Console.
Note: 1. Read all of the instructions. Follow all warnings and instructions.
2. All work must be performed by American Power Conversion (APC
®
) authorized
personnel only.
Electrical Hazard:
1. If you are not sure if your power source is compatible with the
device requirements, consult your power company.
2. The device is designed for use with IT power distribution systems
with up to 230V phase-to-phase voltage.
3. Do not overload the AC branch circuit that provides power to the
rack.
4. To prevent damage make sure all devices are properly grounded.
5. The device is equipped with a 3-wire grounding type plug. Have an
electrician update your outlet if the plug does not fit. Do not attempt
to defeat the grounding plug.
6. Do not exceed the total ampere rating of extension cords if
used. Make sure extension cords or power strips are properly
grounded.
7. Protect the system from sudden changes in electrical power with
a surge suppressor or uninterruptible power supply (UPS).
Warning: 1. Route the power cord and cables so they cannot be stepped on or tripped over.
2. Avoid injury and equipment damage as a result of rack failure. Read and
adhere to the installation and safety instructions that accompany your racks.
Caution:1. Serious damage will result if the device is dropped or falls.
2. Do not block ventilation openings. The Rack LCD Console requires proper air
flow for safe operation.
3. Do not place the device near or over radiators or heat registers.
4. The rack ambient temperature should be not greater than 104°F (40°C).
5. Do not use the device near water. Do not spill any liquid on the device.
6. Do not use liquid or aerosol cleaners. Clean the device with a damp cloth.
7. Use only the hardware provided to install the Rack LCD Console in the rack.
Slide/Rail Caution: Slide/rail mounted equipment is not to be used as a shelf or a work
space.