Filter
Top Products
6 English
INTRODUCTION OTHEROPERATION
1 INSTALLATION AND CONNECTION TO DVR
Use the following procedures to attach the external disc unit to
the DVR.
Docking the unit with the DVR is useful.
z The external disc unit and the DVR must be off before
commencing the following procedures.
1 Remove the four screws from the top of
the external disc unit, and remove the
cover.
Do not lose the four screws as they will be used later.
2 Use two screws (accessory) to attach
the fitting (accessory) to the external
disc unit.
Tightening torque: 0.6 N•m - 0.7 N•m
3 Turn the DVR upside down, and use a
screwdriver to remove the leg (A).
4 Remove the four screws from the sides
of the DVR, and remove the cover.
z If the HDD is mounted in the slave position, remove the
HDD block.
Installation
Call a specialist to install the unit. (Do not try
to install the unit yourself.)
Preparing the external disc unit
Screw
Fitting
Preparing the DVR
(A)
Slave
position
Front panel side
e00_l8hcc_xe_7.book Page 6 Friday, March 11, 2005 7:42 PM