Filter
Top Products
- 7 -
LISTENING TO THE RADIO
1. Set the FUNCTION switch to RADIO.
2. Select the desired radio band with the BAND
switch.
3. Tune in a desired station by turning the
TUNING control.
4. To turn the radio off, set the FUNCTION
switch to TAPE/OFF or CD or LINE IN.
To receive FM stereo broadcasts
Set the FM MODE select switch (the back of the
unit) to ST.
- If the signal from an FM stereo station is weak
and reception is poor, set the FM MODE
select switch to MONO. The reception may be
improved, but the sound will be monaural.
To improve reception
FM: Pull out the telescopic aerial and adjust
its position.
AM: Rotate the unit.
RECORDING
Recording copyright material without permission
of the copyright owners is usually an infringement.
If you wish to re-record copyright material,
permission from the copyright owner is necessary.
SANYO does not approve of, and cannot be held
responsible for, any unlawful use of this machine.
Recording from CD (Synchronous
recording)
1. Load a blank cassette.
2. Set the FUNCTION switch to CD.
3. Load a CD to be recorded.
- Select the track if required.
- For programmed recording, pro-
gramme the material in advance.
4. Press the REC button. The PLAY button
is engaged simultaneously and recording
starts.
5. Press the STOP/EJECT button to stop
recording at any time. When the end of the
tape is reached, deck stop automatically and
the playback of CD enters stop mode.
Recording from the radio or other sources
1. Load a blank cassette.
2. Tune in the radio station to be recorded or play
other sources.
3. Press the REC button to start recording.
4. Press the STOP/EJECT button to stop
recording.
When beat is heard
Beat (a high-pitched noise) may sometimes be
heard during the recording of radio broadcasts.
If this occurs, set the BEAT CANCEL switch (the
back of the unit) to 1 or 2 position that reduces
the level of the beat noise.
Safeguards against accidental erasure
To protect side A, break out tab (1). To protect
side B, break out tab (2).
- To erase or record a protected cassette, cover
the tab openings with adhesive tape (3).
Note:
The REC button cannot be depressed when using
a protected cassette.
540AU.indd 7 2009.4.8 10:11:22 AM