Filter
Top Products
6
E
The RS-332 has an 18' 6" (5.64 meters) control cable that attaches to the RS-330.
Align the cable’s plug with the matching jack on the rear of the RS-330, then
gently push it into place.
There is an FM MODE switch next to the control cable jack on the RS-330. Set
this switch to STEREO, so that stereo broadcasts will be heard in stereo. If
stereo reception is noisy or distorted, and reorienting the antenna does not provide
acceptable reception (this may mean that the broadcast signal is too weak), move
the switch to the MONO position.
POSITIONING THE RS-332
The RS-332 should be placed where it is not exposed to high temperatures or
humidity.
The RS-332 provides high-fidelity stereo sound when paired with the RS-330
Clock Radio. Position the RS-330 and RS-332 for the best stereo sound. They
should be about equally distant from your usual listening position. The farther you
separate the RS-330 and RS-332, the more spacious the sound becomes.
Front-panel control buttons are back-lit for ease of use in a darkened room.
THE DISPLAY
The fluorescent display shows the current time, station frequency, alarm settings,
and most operational modes. Please read the owner’s manual of the RS-330
which describes each element of the display.
A light sensor at the base of the display automatically adjusts the display’s
brightness to compensate for a change in room lighting. This sensor works
independently of the sensor on the RS-330. You can modify the automatic setting
with the knob on the bottom of the RS-332 . Turn this knob clockwise to make
the display brighter, counter-clockwise to make it dimmer.
The display shows either the station frequency, or the current time, but not both
simultaneously. Whenever you turn on the radio, or select a new station, the
display automatically switches to the station frequency. The display will auto-
matically return to the time after seven seconds. If you want to view the frequency
on the RS-332, press the FREQ (frequency) button on the RS-332.
CONTROLS
The VOLUME control adjusts only the level of the RS-332. Set the RS-332’s
volume so that both units are equally loud. Use an announcer’s voice for this
setting. If you are midway between the RS-330 and RS-332, the voice should
appear to be centered when both units are playing at the same volume.
8
19
13