Filter
Top Products
-
-
1.
2.
■
3.
4.
CAM PLAYER
✤
✤ DSC
( VP-D230(i)/D250(i)/D270(i))
ENGLISH
Preparation
2323
Connecting a Power Source
There are two types of power source that can be connected to your
camcorder.
- The AC Power Adapter and AC cord : used for indoor recording.
- The Battery Pack : used for outdoor recording.
To use the AC Power adapter and DC Cable
1. Connect the AC Power adapter to the
AC cord.
2. Connect the AC cord to a wall socket.
Notes
■
The plug and wall socket type may
differ according to your resident
country.
3. Connect the DC cable to the DC jack
socket of the camcorder.
(When the battery is attached on the set,
you should keep outside the projection
of the DC cable.)
4. Set the camcorder to each mode by
holding down the tab on the power
switch and turning it to the CAM or PLAYER mode.
To select the CAMCORDER mode
✤ If you want to use this unit as a camcorder,
set the mode switch to TAPE position.
✤ If you want to use this unit as a DSC
(Digital Still Camera), set the mode switch to
MEMORY STICK position.
(VP-D230(i)/D250(i)/D270(i) only)
MEMORY
STICK
TAPE