Samsung MXF830BZA Stereo System User Manual


  Open as PDF
of 19
 
6 English English 6
English 7
Rear Panel
1. Cooling fan
• Thefanalwaysturnswhenthepowerison.
Provideaminimumof6inches(15cm)ofclear
spaceonallsidesofthefanwhenyouinstallthe
product.
2. 2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on the
rear of the system.
1.
To achieve the correct sound quality, insert the
speaker connector cables identified below into the
correct speaker terminals on the back of the sys-
tem.
• Leftspeaker(markedL).
• Rightspeaker(markedR).
3. ONLY FOR SERVICE
• Thisjackisforserviceonly.Pleasedonotuse.
4. AUX IN 2 Terminals
1.
Use an Audio Cable (not supplied) to connect AUX IN
2 on the product to Audio Out on an external analog
component.
• Besuretomatchconnectorcolors.
• Iftheexternalanalogcomponenthasonlyone
AudioOutjack,connecttoeithertheleftorright
terminal.
• PresstheTUNER/AUXbuttontoselecttheAUX2
input.
• WhentheunitisinAUXmode,ifnoneofthe
buttonsonthefrontpanelarepushedformore
than8hours,thepowerwillautomaticallyturnoff.
5. FM Antenna Connector Terminal
1.
Connect the FM antenna (supplied) to the FM Antenna
jack.
2.
Slowly move the antenna wire until you find a location
where reception is good, then fasten it to a wall or
other rigid surface.
3.
If reception is poor, you may need to install an outdoor
antenna. To do so, connect an outdoor FM antenna to
FM antenna jack on the rear of the system using a
75Ω coaxial cable (not supplied).
6. LED Terminals for the Front Speakers
To enjoy the special light effect of the speakers, connect
the LED cables of the Front Speakers to the LED
terminals of the system.
1
2
3
4
5
6
MX-F830B-ZA-ENG-0228.indd 7 2013-3-13 16:29:19
 previous next