Filter
Top Products
GB
9
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting the AM (MW)/LW Aerial
Connecting the FM Aerial
B
8
The auxiliary input can be used to take advantage of the
sound quality of your micro-component system when listening
to other sources.
Examples: A television
A video disc player
A Hi-Fi stereo video cassette recorder
To connect the external source, the source must have an audio
output. In addition, you need an RCA connection cable.
Set the system to standby mode and disconnect it and the external
source from the main.
Connect the audio cable to the rear of the micro-component system.
Connect the... To the connector marked...
Red jack R (right)
White jack L (left)
For optimum sound quality, do not invert the right and left
channels.
Plug the system back into the main socket and press On/Standby
( ) to switch it on.
Select the AUX source by pressing AUX.
Result
: AUX is displayed.
Switch the external source on.
Adjust the volume and balance as required:
Volume Equalizer
Example: You can watch a film and take advantage of stereo sound
provided that the original sound track is in stereo (as if you
were in a cinema).
Connecting to an External Source
1
2
3
4
5
6
Speaker Connection
Directions in Installing Speaker
Installation in a place near heating apparatus, under direct lay of
light or with high humidity may cause performance degradation of
the speaker.
Do not install on the wall or on a high place of pole or other unsta-
ble place to prevent any safety accident caused by falling of the
speaker.
Do not take the speaker apart from TV or computer monitor.
The speaker near the TV or computer monitor may influence the
quality of the screen display.
(Right Speaker) (Left Speaker)
ANTENNA
AC CORD
ANTENNA
AC CORD
EQ
Down
C
Tuning Mode Up
S.Bass
Volume
Power
Sound
CD
AUX
TUNER
TAPE
Band
There are two types of aerials, follow the instructions below (depending on option chosen).
FM FM
FM AERIAL
(supplied)
75ΩCOAXIAL CABLE
(not supplied)
2
EQ
Down
Mute
Counter
Reset
Repeat
A B
Tuning Mode
REC/Pause
CD Sync.
Up
S.Bass
Volume
Power
Sound
Push Eject
CD
AUX
TUNER
TAPE
Band
1
The loudspeaker connector terminals are located on the rear
of the system (red and black tabs).
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the
right
speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the - terminals
How to connect a SCREW TYPE wire aerial.
The FM aerial connector terminals are located on the rear of the system and marked FM(300Ω).
Spread the T.form FM aerial out and attach the ends to a wall, in the position providing the best reception.
How to connect a COAXIAL TYPE aerial(OPTION).
Connect a 75Ω antenna to the FM aerial terminal.
Plug the connector on the FM aerial supplied into the coaxial socket (75Ω) marked FM (75Ω) on the rear of the system.
Follow the instructions given on Page 13 to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of the system, using a 75Ω coaxial cable (not supplied).