Samsung HW-D551 Speaker User Manual


 
12

The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly)
automatically when main unit is turned on. If the link indicator does not light when main unit and subwoofer are
turned on, please set the ID by following the process below.
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will come on after 30 seconds Link indicator (Blue LED)
blinking.
If you use a device that uses the same frequency (5.2GHz or 5.8GHz) near the system, some
sound interruption may be heard due to interference.
The transmission distance of the wireless signal between the main unit and sub is about 33 ft.,
but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because
the wireless signal cannot penetrate metal.
If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the
connection between the main unit and wireless subwoofer.
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
 Plug the power cords of the main unit and subwoofer into an AC power supply.
 Press the button on the back of the subwoofer with a small, pointed object for 5 seconds.
The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.
STANDBY
LINK
POWER
TV POWER
AUDIO
MUTE
TV INFO
AUTO
POWER
AV SYNC
AH59-02330A
VOL
TV
CH
SOUND
MODE
3D
SOUND
S.VOL
INPUT
SELECT
DIMMER
S/W LEVEL
HDMISPK CONTROL
DRC
POWER
TV POWER
AUDIO
MUTE
TV INFO
AUTO
POWER
AV SYNC
AH59-02330A
VOL
TV
CH
SOUND
MODE
3D
SOUND
S.VOL
INPUT
SELECT
DIMMER
S/W LEVEL
HDMISPK CONTROL
DRC
 While the main unit is powered off (
STANDBY
mode), press

on the remote control for 5 seconds.
 The Power Indicator on the main unit lights off and on, then
returns to  mode.
The main unit and the subwoofer are now linked (connected).
The Link indicator (blue LED) on the subwoofer is turned on.
You can enjoy better sound from the wireless subwoofer by
selecting the sound mode. ( See page 18 )