Filter
Top Products
ENG
25
OPERATION
Disc Playback
1 Press the OPEN/CLOSE button to open the disc tray.
2 Load a disc.
■
Place a disc gently into the tray with the disc’s label facing up.
3 Close the compartment by pressing the OPEN/CLOSE button again.
■
Playback starts automatically.
• Depending on the content of the disc, the initial screen may appear different.
• Pirated discs will not run in this player because it violates the CSS (Content Scrambling System : a copy protection system) rec-
ommendations.
To stop playback, press the STOP (
)
button during playback.
■
If pressed once, <PRESS PLAY> is displayed and the stop position will be stored in memory.
If the PLAY/PAUSE ( ) button or ENTER button is pressed, playback resumes from the stop position.
(This function works only with DVDs.)
■
If pressed twice, <STOP> is displayed, and if the PLAY/PAUSE ( ) button is pressed, playback starts from
the beginning.
To temporarily pause playback, press the PLAY/PAUSE ()button during playback.
■
To resume playback, press the PLAY/PAUSE ( ) button again.
24
Before Using Your Home Theater
To Operate your Samsung TV and the Home Theater with the HT-X30/HT-TX35's Remote Control
1 Plug the main unit's power cord into the AC power supply.
■
Before plugging your system into a main socket, you must check the voltage setting.
If the voltage of the socket does not correspond to the setting on the rear of the unit, you
may seriously damage your system.
2 Press the TV button to set the remote to TV mode.
3 Press the POWER button to turn on your Samsung TV
with this remote.
4 Press the TV/VIDEO button to select VIDEO mode on your TV.
5 Press the DVD RECEIVER button to switch to DVD RECEIVER mode to
operate the DVD Home Theater
6 Press the FUNCTION button on the main unit or DVD button
on the remote to enable DVD/CD playback.
Press and hold the NT/PAL button on the remote controller for over 5 seconds
while the power is turned off.
By default, the video format is set to <PAL>.
<NTSC> or <PAL> will appear in the display. At this time, press the NT/PAL button shortly to
select between <NTSC> and <PAL>.
Each country has a different video format standard.
For normal playback, the video format of the disc must be the same as the video format of your TV.
Selecting the Video Format
VIDEO
The DVD Home Theater's remote can be used to control Samsung TVs.
DVD VCD CD
X30_TX35(1~39P) NOGB 2007.4.10 10:35 AM Page 24