Filter
Top Products
24
connections
When you have Purchased the Wireless Receiving Module (SWA-4000)
Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be removed
easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the DVD Player is turned off. Inserting the card when it is turned
on may cause a problem.
If the TX Card is inserted and wireless receiving module setting is complete, sound is not output
from the Rear Speaker connectors on the main unit.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit away
from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
If no sound is heard from the wireless rear speakers, switch the mode to
DVD 5.1 channel or Dolby ProLogic II .
In 2-CH mode, no sound will be heard from the wireless rear speakers.
`
`
`
`
`
`
`
`
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module
is too close to the main unit, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment,
or any other device that uses the same frequency (5.8GHz) near the system, some sound
interruption may be heard due to interference.
The transmission distance from the main unit to the wireless receiving module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall
or metallic wall is between the main unit and the wireless receiver module, the system may
not operate at all, because the radio wave cannot penetrate metal.
This product(HT-TWZ312/HT-TWZ-315) is also compatible with the wireless receiver
module SWA-3000.
If the main unit doesn't make wireless connection, the system needs ID Setting between
main unit and wireless receiver module. With the main unit turned off, press remote
control's number button "0""1""3""5" and unit turned on. With the wireless receiver
module turned on, press "ID SET" button on the back of the wireless receiver for 5 seconds.
M
`
`
`
`
`
CONNECTING THE WIRELESS RECEIVING AMPLIFIER (CON'T)
HT-TWZ312(315)_XAC(ENG)_0220.ind24 24 2008-02-20 �� 3:54:27