Filter
Top Products
ENG
12
Your system is equipped with a clock which allows you to turn your
system on and off automatically.
You should set the clock:
When you first purchase the micro-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing POWER.
Press TIMER/CLOCK twice.
Result: CLOCK is displayed.
Press PROGRAM/SET.
Result: The hour flashes.
To... Press the TUNING button
Increase the hours
Decrease the hours
When the correct hour is displayed, press PROGRAM/SET.
Result: The minutes flash.
To... Press the TUNING button
Increase the minutes
Decrease the minutes
When the correct time is displayed, press PROGRAM/SET.
You can display the time, even when you are using another
function, by pressing TIMER/CLOCK once.
You can also use or
buttons on the main unit to instead
of TUNING button
or in step 4, 6.
Setting the Clock
1
2
3
4
5
6
7
DEMO/DIMMER function
All functions available on the system can be viewed on the display
and the display's brightness can be switched between "on" and "off".
Press the
DEMO/DIMMER
button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to the
relevant section.
Press the
DEMO/DIMMER
button.
Result: The Dimmer function is selected and the display darkens.
Press the
DEMO/DIMMER
button once again to brighten the front
panel display.
A display brightness control can only be performed while the system
power is on.
2
1
3
3,5,7
4,6
4,6
2
4,6
4,6
1,2,3
1
MM-C430-XAC-ENG-MIC.indd 12MM-C430-XAC-ENG-MIC.indd 12 2010-9-2 15:30:402010-9-2 15:30:40