Filter
Top Products
ENG
5453
SETUP
12
In Stop or no disc
mode, press
MENU button.
Press Cursor
button to move to
‘Audio’ and then
press ENTER
button.
•
When the Cursor button is pressed,
the effect is greater, and when the
Cursor button is pressed, the effect is
smaller.
34
Press Cursor
button to move to
‘DRC’ and then
press ENTER
button.
Press Cursor
, to adjust
the ‘DRC’.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
Setting the DRC (Dynamic Range Compression)
L: Front Speaker (L) C: Center Speaker SW: Subwoofer
R: Front Speaker (R) SL: Rear Speaker (L) SR: Rear Speaker (R)
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
21
In Stop or no
disc mode,
press MENU
button.
Press Cursor
button to move to
‘Audio’ and then
press ENTER button.
3
Press Cursor button
to move to ‘TEST
TONE’ and then press
ENTER button.
•
The test tone will be sent to L ➝ C ➝
R ➝ SR ➝ SL ➝ SW in order.
If the ENTER button is pressed again
at this time, the test tone will stop.
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work only in Stop mode.
•
Use this function to check that each speaker is correctly
connected and that there is no problem.
•
When there is no input signal from the HDMI IN function, the
Test Tone will not work.
To end the test tone,
press TEST TONE button again.
Alternate method: press the TEST TONE button on the remote.
Multi-Channel Pro Logic Mode
Start
Use the Test Tone feature to check the speaker connections.
Setting the Test Tone