Samson RXA5 Headphones User Manual


 
1. VOLUME Controls the amount of overall output level.
2. LF EQ – Rotary control to raise or lower the low frequency shelving equalizer filter
by +/-6 dB. This control should be used to "fine-tune" the speaker to match your
listening environment.
3. HF EQ – Rotary control to raise or lower the high frequency shelving equalizer
filter by +/-6 dB. This control should be used to "fine-tune" the speaker to
match your listening environment.
4. XLR Input – Connect a balanced, +4dBu, line level signal here via standard XLR
(microphone) cable.
5. ¼” Input – Connect a balanced, +4dBu, line level signal here via a TRS (Tip,
Ring, Sleeve), or unbalanced TS (Tip, Sleeve) ¼”cable.
6. RCA Input – Used to connect signals from unbalanced, –10dBV devices.
7. POWER Switch – Use this switch to turn the speakers on and off. When powered
on, the front panel LED will light.
8. AC Inlet – Connect the supplied IEC power cable here.
9. Voltage Switch – Used to select the operating voltage.
NOTE: Be sure to check that the voltage setting and fuse rating are correct for your country.
10. Wall Mount Points – Two M6x10 thread inserts for mounting the speakers on a
stand or wall.
11. Bass Reflex Port – Rear firing port provides minimal air turbulence and enhances
the linear low frequency response
Rear Panel Callouts
4