Filter
Top Products
18
PLAYING BACK A CD USING 2T TO MIX
The MDR1248 and MDR1688 has a dedicated input for
playing back a stereo device such as a CD, Tape or Mini
Disk. Below is a description of how you can play back
a CD, Tape or MD using the MDR1248 and MDR1688’s 2
TRACK INPUT.
1. Turn the MAIN level control all the way down.
2. Press the 2TK TO MIX button down.
3. Adjust the MAIN LEVEL control in the master section
to the "0" position.
4. Start playback on the CD, Tape or MD player, and use
the 2 TK LEVEL control to set the desired level.
RECORDING A MIX FROM THE MDR1248 and
MDR1688
You can record the audio from the MDR1248 and
MDR1688’s mixer section including the MIC, LINE, 2T IN
and AUX inputs to a Cassette deck, MD, DAT or any other
type of recorder using the 2T OUT outputs. Simply con-
nect the MDR1248 and MDR1688’s 2 TRACK OUT to the
input jacks of the recorder as shown in the diagram on
the right and follow the steps below.
1. Adjust the MAIN LEVEL control in the master sec-
tion to the "0" position.
2. Set a clean signal using the recorder’s input level
controls and meters.
3. Press RECORD.
4. Play back using as described in the previous section
"PLAYING BACK A CD USING 2T TO MIX".
NOTE: To avoid feedback, be sure to keep the 2TK LEVEL
control knob all the way down while recording with the
2TK outputs.
Operating the MDR1248 and MDR1688
USING AN EXTERNAL EFFECT
If you prefer to use an external device for effects process-
ing, you can easily connect the unit using the MDR1248
and MDR1688 AUX 2 bus. Follow the simple steps below
to interface your processor:
1. Connect the AUX 2 OUTPUT to the input of the
external effect processor.
2. Connect the outputs of the effect processor to
the AUX 2 RETURN located on the MDR1248 and
MDR1688’s master section.
3. Set the MAIN LEVEL control to the "0" position.
4. Raise the AUX 2 knobs for the channels to which you
want the external effect to be applied.
5. Set the input level of the external effect so that the
sound is not distorted and so that the effect’s input
meter does not indicate a clipped signal.
6. Use the AUX RETURN 2 control to adjust the level of
the effects processed by the external effects device.