Filter
Top Products
5
Controls and Functions
1: Power switch - Use this to power the F1200 / F800 on or off.
2: Power LED - Lights whenever the F1200 / F800 is powered on.
3: Peak LED (Ch1 Ch2) - The Channel 1 and Channel 2 Peak LEDs light whenever the input signal is
about to clip. This is not a problem if the Peak LEDs should light occasionally during peak levels, but if it
lights frequently, you may be overloading the F1200 / F800 and a distorted (“clipped”) signal is probably
being output. If this occurs back off the Output Level control of the device connected to the input of the
F1200 / F800 until the LEDs light only occasionally.
4: Bridge LED - This LED lights when the F1200 / F800 is in Bridged mode.
5: Air Intake Vents - These vents and the vents on the sides of the F1200 / F800 allow air to be drawn
over the heat sinks by the internal fan. This keeps the amplifier from over heating. Never block these
vents when the amplifier is on. Remove any dust that may build up on the protective screen.
F1200
600W X 2 STEREO
F1200 STEREO HIGH PERFORMANCE 1200WATT AMPLIFIER
POWERBRIDGEPEAK CH 1 PEAK CH 2
ON
OFF
POWER
13 3
5
42