7
The C02 can be connected to any mixer, mixer/amplifier, or mic preamp using a
standard microphone cable. As shown in the wiring diagrams below, connect the
female XLR end directly to the C02’s gold-plated connector and the other end
(normally a male XLR end, although some mixers use 1/4" connectors) to the
mixer, mixer/amplifier, or mic preamp.
C02 Frequency Chart
C02 Specifications
Type Condenser
Polar Pattern Cardioid
Frequency Response 40~20000 Hz
Sensitivity -40 dBV/pa (10mv/pa)
Raded Impedance 200Ω
Equivalent Noise level 22 dB (A weighted IEC/DIN 651)
Max. SPL 134 dB (THD≤ 0.5% 1000 Hz)
Dynamic Range 112 dB
Power Supply 48V Phantom Power (IEC 268-15/DIN
45596)
Current Consumption 3.5 mA
Dimensions ø 20 x 150 mm
Weight 170g
Wiring Guide and Specifications