Filter
Top Products
AirLine 88 Headset Wireless System 13
The CR88 receiver can be installed into a standard 19” rack for transport or permanent
installation using the included rack ears. Follow the simple steps below to mount the CR88:
Attach the included rack ears by sliding each rack ear
into the groove on either side of the CR88 until they
lock into place, and the receiver flush with the front
panel.
Position the CR88 receiver into an
available rack space and slide in until
the rack ears are touching the rails of
the rack case and are aligned with the
rack rail holes.
Mount the receiver into the rack using the appropriate size rack screws (not included). To
ensure equal tension and balance when installing the receiver, you should secure screws
in a crisscross pattern of opposite corners: top left -> bottom right -> top right -> bottom
left.
In order to mount two CR88 receivers in
one rack space, the system includes a
center connection piece. Slide the center
connection piece into the groove of each
receiver and attach the short rack ears to
each receiver. Mount the receivers into
the rack using the crisscross pattern
described above.
Rack Mounting
Note: Receivers should be mounted in the top rack position with additional audio
units mounted below. Digital audio devices should be mounted as far as possible
below the CR88 receivers.