Filter
Top Products
18
Samson AirLine
13. Temporarily turn down the level of your mixer/amplifier system and turn off the power to your transmitter, leaving the receiver on.
Then restore the previously set level of your mixer/amplifier. With the transmitter off, the receiver output should be totally silent—if it
is, skip ahead to the next step. If it isn’t (that is, if you hear some noise), you may need to adjust the receiver Mute (squelch) control.
When the Mute control is at its minimum setting, the AirLine system always provides maximum range without dropout; however,
depending upon the particular environment your system is used in, you may need to reduce that range somewhat in order to eliminate
band noise when the AH1 transmitter is turned off. To do so, use the provided screwdriver to rotate the Mute (squelch) control
completely counterclockwise (to the “Min” position), then slowly turn it clockwise until the noise disappears. If no noise is present at
any position, leave it at its fully counterclockwise “Min” position (so as to have the greatest overall range available).
14. When first setting up your AirLine System in a new environment, it’s always a good idea to do a walkaround in order to make sure
that coverage is provided for your entire performance area. Accordingly, turn down the level of your audio system and turn on both
the transmitter and receiver. Then, with the transmitter unmuted, restore the level of your audio system and while speaking or singing,
walk through the entire area that will need to be covered. As you do so, observe the RF display or meter on the receiver to make sure
that it is receiving sufficiently strong RF signal (in the AR1 receiver, the “Power On / RF” LED should always remain lit steadily green;
in the UR1 and UM1 receivers, all segments of the RF Level meter should be lit). Always try to minimize the distance between trans-
mitter and receiver as much as possible so that the strongest possible signal is received from all planned transmission points. If you are
using an AR1 receiver in fixed installations such as A/V or corporate conference rooms, you may find it handy to mount it in the sup-
plied wall-mount holder. In certain environments, it may be desirable to angle the receiver antenna(s) differently from the vertical
position. Where extended range coverage is required, the Samson UR1 true diversity receiver (set to the same channel as the trans-
mitter) should be used. For videography applications, the Samson UM1 micro diversity receiver should be used.
If you have followed all the steps above and are experiencing difficulties, contact your local distributor or, if purchased in the
United States, call Samson Technical Support (1-800-372-6766) between 9 AM and 5 PM EST.
Setting Up and Using Your AirLine System
ENGLISH